Figure 10. F900 node LCD display
Item Button or Display Description
1 Left Moves the cursor back in one-step
increments
2 Select Chooses the selected menu item
3 Right Moves the cursor forward in one-step
increments during message scrolling:
1. · Press and hold the right button to
increase scrolling speed.
2. Release the button To stop scrolling,
release the button.
NOTE: The display stops scrolling
when the button is released. After
45 s of inactivity, the display starts
scrolling.
4 LCD Display Displays system information, status, and
error messages or iDRAC address
View the Home screen
The Home screen displays user-configurable information about the system. This screen is displayed during normal system
operation when there are no status messages or errors. When the system is off and there are no errors, the LCD enters standby
mode after five minutes of inactivity. Press any button on the LCD display to turn it on.
1. To view the Home screen, press one of the three navigation buttons (Select, Left, or Right).
2. To go to the Home screen from another menu, complete the following steps:
a. Press and hold the navigation button until the up arrow is displayed.
b. Go to the Home icon by using the up arrow.
c. On the Home screen, press the Select button to enter the main menu.
d. Select the Home icon.
Setup menu
NOTE: When you select an option in the Setup menu, confirm the option before going to the next action.
F900 node configuration 17
To Next Page
Loading...
