F900 node installation
This document describes how to install F900 nodes into an equipment cabinet.
Topics:
• Before you begin
• Rail kit components for 2U systems
• Install the rails
• Secure the rail assemblies to the cabinet
• Install the system in the cabinet
• Install the front bezel
• Connect and route cords and cables
Before you begin
WARNING: Before you begin, read and follow the safety instructions in any Safety, Environmental, and
Regulatory information document shipped with the system.
WARNING: To avoid injury, do not attempt to lift the system by yourself.
NOTE: The figures in this document do not represent a specific system.
NOTE: The rail kit is compatible with square, unthreaded round, and threaded round hole racks.
Rail kit components for 2U systems
The sliding rail assemblies are used to secure the node in the cabinet, and extended from the cabinet so that the system cover
can be removed to access the internal FRUs. The sliding rail assembly (2U) is used for installation of the F900 nodes.
Figure 1. Sliding rail assembly - 2U systems
2
6 F900 node installation
To Next Page
Loading...
