Dell EMC PowerVault MD3060e - Command Help

Table 3. Description of values for parameters
Description Valid for Parameter
Absolute Path to Firmware File
Indicates the absolute lepath to a valid
drive or EMM rmware le
Valid value for the –file parameter
Adapter Index
Indicates the enumerated index value for
installed supported HBAs
Valid value for the -a parameter
SAS WWID
Indicates the device specic SAS WWID of
the installed supported HBAs
Valid value for the -a parameter
Device ID
Enumerated reference value that Indicates a
target drive or EMM
Valid value for the -d and -emm
parameters
Drawer Index
Indicates reference value for logical grouping
of drives into drawers
Valid value for the -w parameter
Encl Index (Enclosure Index)
Indicates reference value for enclosures
attached to a specied adapter
Valid value for the -enc parameter
WWN (Worldwide Name)
Indicates unique value that identies a
unique drive, EMM, or enclosure
Valid value for the -d, -emm, and -enc
parameters
Enclosure Slot Index
Reference value that Indicates a target drive Valid value for the -d and-s parameter
Drawer Slot Index
Indicates reference value for a drive slot in a
specied drawer
Valid value for the -d parameter
EMM Index (Enclosure Management Module
Index)
Indicates the reference value for EMMs in an
specic enclosure
Valid value for the -emm parameter
StartDate
Starting date to view logs in the format:
MM/DD/YY
Valid value for the -startDate parameter
EndDate
End date to view logs in the format:
MM/DD/YY
Valid value for the -endDate parameter
EventType
Type of event to view (INFO, CRITICAL,
ERROR, or WARN)
Valid value for the -event parameter
LatestEventCount
Numeric value between 1–1000 Valid value for the -count parameter
SupportedOutputFormats
Supported out le formats: XML, JSON Valid value for the -outputformat
parameter
Serial Number
Unique identier for the physical disk drive. Valid value for the -d parameter
Drive OS Path
Unique path to drive provided by the OS. Valid value for the -d parameter
NOTE: Ensure the console window is able to t at least 150 characters for each line to view the output properly.
NOTE: The output screenshots shown in the following procedures are examples and may be slightly dierent from the actual
output depending on the version of your Server Hardware Management Software.
Command help
To get a list of all available commands:
16
SHM CLI