Dell EMC PowerVault MD3060e - CLI Reference Guide; SHM CLI Commands by Type; SHM CLI Drive Commands

CLI reference
This section lists all the commands available for managing your storage enclosure.
Commands listed on the basis of command type
Topics:
• Drive commands
• List commands
• Informational commands
Drive commands
Blink drive
Description
Helps visually locate the specied SCSI device by initiating a blink, or ending an existing blink session.
Command syntax
shmcli (blink drive | blinkdrive | bd) (-a=<(SAS WWID | AdapterIndex)> [-enc=<(WWN |
EnclIndex)> [-w=<DrawerIndex>]] -d=<(WWN | EnclosureSlotIndex | DrawerSlotIndex | Serial Number
| Drive OS Path)> [-off] | -d=<(WWN | Serial Number | Drive OS Path)> [-off] | [-h])
Parameters
Table 4. Drive commands
Parameter Description
-a
Species the adapter to use for the command. This can be either
SASAddress or AdapterIndex.
-enc
Species the enclosure to use for the command. This is either
WWN or EnclIndex.
-w
Species the drawer index used for the command.
-d
Species the drive used for the command. This can be any of the
following:
• WWN — Can be used anytime.
6
CLI reference 21