Dell EMC PowerVault MD3060e - List Drives

Parameters
Table 7. List physical enclosure
Parameter Description
-a
Species the adapter used for the command. This is either SAS WWID or
AdapterIndex.
-h
Provides more information about the command, description, and usage.
-outputformat
You can specify the following output formats: XML or JSON.
Command examples
• list physical enclosures
• list physical enclosures -a = 1
• list physical enclosures -a = 500abcdefgh12345
List drives
Description
Shows the list of HDDs or SSDs and related information for the specied device. If no device is specied to obtain drives for, all drives
accessible by supported adapters in the local system are listed.
Command syntax
shmcli (list drives | listdrives | ld) ([-a=<(SAS WWID | AdapterIndex)>] [-enc=<(WWN |
EnclIndex)> [-w=<DrawerIndex>]] [-outputformat=<SupportedOutputFormats>] [-verbose] | -
enc=<WWN> [-w=<DrawerIndex>] [-outputformat=<SupportedOutputFormats>] [-verbose] | [-h])
Parameters
Table 8. List hard disk drive
Parameter Description
-a
Species the adapter used for the command. This is either SAS
WWID or I.
-enc
Species the enclosure used for the command. This is either WWN
or EnclIndex.
-w
Species the drawer index used for the command.
-h
Provides more information about the command, description, and
usage.
-outputformat
You can specify the following output formats: XML or JSON.
24 CLI reference