Dell EMC PowerVault MD3060e - Updating Adapter Firmware via SHM CLI; Checking Adapter Status

NOTE: If the le name contains special characters, you must enclose the le path within escaped double quotation marks.
Command examples
• update emm -a = 500abcdefgh12345 -enc = 1 -emm = 0 -file = C:\Users\Administrator\firmwares
\emm_upgrade.esm
•
update emm -enc = 500rg67890123456 -emm = 500a123456789012 -file = C:\Users\Administrator
\firmwares\emm_upgrade.esm
• update emm -emm = 500a123456789012 -file = C:\Users\Administrator\firmwares\emm_upgrade.esm
Update Adapter
Description
After running the following command, the updated rmware le’s version is installed.
Command syntax
shmcli (update adapter | updateadapter) ( -a=<(SAS WWID | AdapterIndex)> -file=<FW.FilePath> |
[-h])
Parameters
Table 27. Update Adapter
Parameter Description
-h, -help
Provides more information about the command, description, and
usage.
-outputformat
Following output formats can be specied: XML, JSON.
-a, -adapter
Species the adapter to be used for the command. This can either
be the SAS WWID or the Adapter Index.
-file
Species the le at the given path used for the command.
NOTE: If the lename contains special characters, you must enclose the le path within escaped double quotation marks.
Status Adapter
Description
Shows information about the specied adapter status including PHY and expander information.
Command syntax
shmcli (status adapter | statusadapter | sa) (-a=<(SAS WWID | AdapterIndex)> [-
outputformat=<supportedOutputFormats>] | [-h])
Parameters
Table 28. Status Adapter
Parameter Description
-h, -help
Provides additional information about the command, description,
and usage.
-outputformat
Following output formats can be specied: XML, or JSON.
-a, -adapter
Species the Adapter to be used for the command. This can either
be the SAS WWID or the Adapter Index.
Update commands 39