Connect to the management network
Perform the following steps to connect a controller enclosure to the management network:
1. Connect an Ethernet cable to the network port on each controller module.
2. Connect the other end of each Ethernet cable to a network that your management host can access, preferably on the same subnet.
NOTE: If you connect the iSCSI and management ports to the same physical switches, Dell EMC recommends using
separate VLANs.
Figure 16. Connect a 2U controller enclosure to the management network
1.
Controller module in slot A 2. Controller module in slot B
3. Switch 4. SAN
Figure 17. Connect a 5U controller enclosure to the management network
1.
Controller module in slot A 2. Controller module in slot B
3. Switch 4. SAN
NOTE: See also the topic about configuring network ports on controller modules in the
Dell EMC PowerVault ME4 Series
Storage System Administrator’s Guide
.
3
Connect to the management network 21
To Next Page
Loading...
