6. Connect a qualified fiber-optic interface cable into the duplex jack of the SFP+ transceiver.
If you do not plan to use the SFP+ transceiver immediately, reinsert the plug into the duplex jack of SFP+ transceiver to keep its optics
free of dust.
Verify component operation
View the port Link Status/Link Activity LED on the controller module face plate. A green LED indicates that the port is connected and the
link is up.
NOTE: To remove an SFP+ transceiver, perform the installation steps in reverse order relative to what is described in
Install an SFP+ transceiver.
84 SFP+ transceiver for FC/iSCSI ports
To Next Page
Loading...
