Item Description Item Description
4 Clamping screw (B) 11 Fastening screw (C)
5 Clamping screw (B) 12 Key: Rail kit fasteners used in rackmount installation
6 Rail location pins (quantity 4 per rail) (A= fastening; B= clamping; C= fastening)
7 ME484 JBOD chassis section shown for
reference
4. Fully tighten all clamping screws and middle slide locking screws.
5. Ensure the four rear spacer clips (not shown) are fitted to the edge of the rack post.
6. Slide the enclosure until fully seated on its rails.
7. Fasten the front of the enclosure using the enclosure fastening screws (x4) as shown in Figure 1. Secure brackets to the rail (left hand
rail shown for ME484 JBOD).
8. Fix the rear of the enclosure to the sliding bracket with the rear enclosure fastening screws.
CAUTION: Once the enclosure is installed in the rack, dispose of the lifting straps. The straps cannot be used to remove
the enclosure from the rack.
Reinsert the rear panel modules and install the DDICs into the drawers. See the instructions in the Dell EMC PowerVault ME4 Series
Storage System Owner’s Manual.
• Installing an IOM
• Installing a fan cooling module
• Installing a PSU
• Installing a DDIC
Mount the enclosures in the rack
7
To Next Page
Loading...