User interface
You can access the Edge 600 Series platform user interface (UI) at https://edge.velocloud.net or at the default IP address of 192.168.2.1
using one of the default LAN ports, GE1 or GE2, or through the WiFi connection.
The WiFi default SSID is shown on the Overview page under Switched Interfaces / Wireless. This SSID defaults to velocloud-XXX
where XXX is the last 3 digits of the serial number. The default password for the WiFi connection is vcsecret.
The platform UI includes local web pages—Overview, Properties, and Reset Settings, as well as a Diagnostic dump button that
provides troubleshooting functions and information about the interfaces.
NOTE: Use the UI only for initial configuration and troubleshooting when the Internet is not available. Do not use the
platform UI during normal operations because the information and configurations are available through the VeloCloud
Orchestrator.
Topics:
• Overview
• Properties
• Reset settings
Overview
The Overview page provides the status of your routed interfaces (WAN) and switched interfaces (LAN) connections.
The top half of the screen displays a diagram of the device. If connections are active, green indicator lights display on the hardware
diagram—in this case, GE1 is a valid LAN connection and GE3 is a valid WAN connection. Next to the device image are two buttons,
Overview and Details. Click the Details button to display WAN and LAN connection status information.
Underneath the device diagram, the status of the WAN and LAN connections display. In this area, change the display by clicking the
Connected, Both, or Unconnected buttons.
If you click a WAN connection, a properties page for that connection opens.
NOTE:
From the Overview page, you can click the Reset Settings button or the Download Diagnostic Bundle button to
obtain a diagnostic dump file.
5
User interface 19
To Next Page
Loading...
