Figure 43. Network adapters
12. From the Configure Management Network main screen, select IPv4 Configuration and press Enter.
13. Within the IPv4 Configuration screen, select the Set Static IPv4 address and network configuration option.
14. Using the arrow keys, go to the IPv4 Address, Subnet Mask, and Default Gateway fields and enter the required information.
15. After entering the required information in each field, press Enter to save the changes.
Figure 44. IPv4 configuration screen
16. Press the Esc key, then press the Y key to confirm the changes you made and to restart the management network.
Figure 45. Confirm management network settings screen
17. From the menu, select Troubleshooting Options and press Enter.
18. From the Troubleshooting Mode Options menu, select Enable ESXi Shell.
19. Press Enter to enable the service.
20. Log in to the ESXi shell.
21. Access the passthru.map file at /etc/vmware/passthru.map and add the following entries:
168c 003c d3d0 false
Download and install VMware ESXi 6.7
31
To Previous Page
Loading...
