✓ Configure your selected external management VLAN (recommended is untagged/native).
✓ If applicable, configure your internal management VLAN
✓ Confirm that IPv6 multicast is configured/enabled on either the external management VLAN (prior to version 4.7) or
internal management VLAN (version 4.7 and later)
✓ Configure your selected VLANs for vSAN, vSphere vMotion, and VM Networks.
✓ If applicable, configure your witness traffic separation VLAN
✓ In multi-switch environments, configure the management and vSAN VLANs to carry the multicast and unicast traffic
respectively between switches.
✓ Configure uplinks to carry upstream network VLANs
✓ Configure one port as an access port for laptop/workstation to connect to VxRail Manager for initial configuration
✓ Confirm configuration and network access.
✓ Configure your workstation/laptop to reach the VxRail Manager initial IP address.
✓ Configure the laptop to reach the VxRail Manager IP address after permanent IP address assignment
To Next Page
Loading...
