Dell 6100 - Table C-3. Microprocessor Module Jumper Settings

Jumpers, Switches, and Connectors C-7
See Table C-3 for the microprocessor module jumper
settings.
Table C-3. Microprocessor Module Jumper Settings
Jumper Setting Description
J101 (default) A processor is not installed in the adjacent slot.
This jumper is useful only when you are using ITP.
A processor is installed in the adjacent slot.
J105 (default) A 200/66 MHz microprocessor is installed.
J106 (default) A processor is not installed in the adjacent slot.
This jumper is useful only when you are using ITP.
A processor is installed in the adjacent slot.
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and acronym list.
jumpered
unjumpered