Dell 8 - Mode

110 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
mode
6
mode
Sets the LLDP mode on the switch.
Synopsis mode tx | rx
no mode
Operands tx Specifies to enable only the transmit mode.
rx Specifies to enable only the receive mode.
Defaults Both transmit and receive modes are enabled.
Command
Modes
Protocol LLDP configuration mode
Description Use this command to set the LLDP mode on the switch. Use the no mode command to return to the
default setting.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To enable only the transmit mode:
switch(conf-lldp)#mode tx
See Also show lldp