Scanning 273
d
Press the button repeatedly to display
TO
or
BCC
as a destination type, and then press the (
Set
)
button.
5
Press the button until
Preferences
is highlighted, and then press the (
Set
) button.
6
Ensure that
From Setting
is highlighted, and then press (
Set
) button.
NOTE: If this setting item is not displayed, make sure that Edit From Field is set to Enable. For details, see "Edit
From Field" on page 198.
7
Specify the sender address of the e-mail using the numeric keypad or the Address Book.
The specified address is notified to the recipient when the e-mail is sent. If no e-mail address is specified here, the
address in
Reply Address
is notified as a sender information instead. For details, see "E-Mail Alert" on
page 129.
NOTE: Be sure to specify an e-mail address either in From Setting or in Reply Address. Otherwise, the
printer cannot start sending the e-mail.
8
Configure the scan settings as necessary.
Settings such as file format and color mode are available. For details about setting items, see "Scan Defaults" on
page 168.
9
Ensure that
Start Scan
is highlighted, and then press the (
Start
) button.
To Next Page
Loading...
