Steps
Place the palmrest assembly on a flat surface.
Next steps
1. Install the speakers.
2. Install the system board.
3. Install the Input Output board.
4. Install the display assembly.
5. Install the keyboard.
6. Install the WWAN card for 4G LTE enabled systems.
7. Install the battery.
8. Install the base cover.
9. Follow the procedure in after working inside your computer.
Removing palmrest assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove WWAN card for 4G LTE enabled systems.
5. Remove keyboard.
6. Remove the display assembly.
7. Remove Input Output board.
8. Remove system board.
9. Remove speakers.
About this task
The following image indicates the location of the palmrest assembly and provide a visual representation of the removal
procedure.
Removing and installing components
59
To Next Page
Loading...
