Dell Chromebook 5190 - Display Assembly

Installing system board
1 Align the screw holes on the system board with the screw holes on the system.
2 Replace the 3 screws to secure the system board to the system.
3 Align the system board bracket and snap the hook on the bracket to the retention tab in the system.
4 Place the system board bracket and replace the single screw to secure the bracket to the system.
5 Connect the eDP cable to the connector in the system board.
6 Ax the adhesive tape to secure the eDP cable to the system board.
7 Place the eDP bracket over the connector and replace the single screw to secure the eDP bracket to the system board.
8 Connect the speaker cable to the connector in the system board.
9 Connect the 2 Input/Output cable, touchpad cable and keyboard cable to the connectors on the system board.
10 Install the:
a battery
b base cover
c microSD card
11 Follow the procedure in After working inside your computer.
Display assembly
Removing display assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
3 To remove the display assembly:
a Remove the single (M2x4) screw that secures the eDP bracket to the system board [1].
b Remove the eDP bracket away from the system [2].
c Peel the adhesive tape that secures the eDP cable to the system board [3].
d Lift the latch and, disconnect the eDP cable from the connector on the system board [4].
e Peel the adhesive tape that secures the cable to the system [5].
Removing and installing components
29