g Place the system in a 90° position on the edge of a plane surface with the display facing down.
h Remove the 6 (M2.5x5) display hinge bracket screws that secure the display assembly to the system [1].
i Lift the display assembly away from the system [2].
Installing display assembly
1 Place the chassis on the edge of a plane surface.
2 Align the display assembly with the screw holders on the system.
3 Replace the 6 display hinge bracket screws to secure the display assembly to the system.
4 Lift the system and close the display.
5 Connect the eDP cable to the connector on the system board.
6 Ax the adhesive tape to secure the eDP cable to the system.
7 Place the eDP metal bracket to secure the eDP cable.
8 Replace the single screw to secure the eDP bracket to the system.
9 Install the:
a battery
b base cover
c microSD card
10 Follow the procedure in After working inside your computer.
Removing and installing components
31
To Next Page
Loading...
