58 Removing and Installing Parts
www.dell.com | support.dell.com
13
Check all cable connections, and fold cables out of the way to provide airflow for the fan and
cooling vents.
14
Replace the computer cover (see page 68).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
15
Connect your computer and devices to electrical outlets, and turn them on.
16
After you turn on your computer, press <F2> when you are prompted to enter setup mode.
17
Highlight
Drive Configuration
and press <Enter>.
18
Use the left and right arrows to change
Diskette Drive A
from
Not Installed
to
3.5 inch,
1.44 MB
.
19
Press <Enter>.
20
Highlight
Integrated Devices (LegacySelect Options)
and press <Enter>.
21
Ensure that the
Diskette Interface
entry is set to
Auto
. If necessary, use the left and right
arrows to set it to
Auto
.
front panel
side hinges (3)
To Next Page
Loading...
