Removing and Installing Parts 65
7
Align the notch on the bottom of the module with the crossbar in the connector.
NOTICE: To avoid damage to the memory module, press the module straight down into the connector
while you apply equal force to each end of the module.
8
Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the
module.
9
Replace the computer cover (see page 68).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
10
Connect your computer and devices to electrical outlets, and turn them on.
11
Right-click the
My Computer
icon and click
Properties
.
12
Click the
General
tab.
13
To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
notch
memory module
cutouts (2)
crossbar
To Next Page
Loading...
