System Setup: Dell Dimension 9150 Service Manual
file:///T|/htdocs/systems/dim9150/en/sm/syssetup.htm[10/31/2012 7:59:07 AM]
a. Locate the 3-pin CMOS jumper (RTCRST) on the system board (see "Clearing Forgotten Passwords").
b. Remove the jumper plug from pins 1 and 2.
c. Place the jumper plug on pins 2 and 3 and wait approximately five seconds.
d. Replace the jumper plug on pins 1 and 2.
3. Replace the computer cover
.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
4. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
To Next Page
Loading...
