1 USB port 2 diagnostic, hard drive activity,
and network lights
3 headphones connector
4 microphone connector 5 thermal sensor connector 6 Integrated audio connector with
jumper block installed
Removing the I/O Panel
1. Follow the procedures in Before You Begin.
2. Remove the computer cover (see Removing the Computer Cover).
3. If your computer includes a card retention mechanism to secure the x16 card, press the release tab downward gently
and then pivot the mechanism upward.
4. Unhook the floppy drive cable from clips on processor shroud and move it out of the way.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (56 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
