2. Remove the computer cover (see Removing the Computer Cover).
3. Unpack the replacement hard drive, and prepare it for installation.
4. Check the documentation for the drive to verify that the drive is configured for your computer.
5. If your replacement hard drive does not have the hard drive bracket attached, remove the bracket from the old hard
drive by unsnapping it from the drive.
6. Snap the hard drive bracket onto the replacement hard drive.
7. Install the hard drive into the computer by sliding the drive into place until you feel it click into place.
1 hard drive 2 hard drive bracket
8. Connect the power and hard drive cables to the hard drive.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (31 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
