Installing the system into the enclosure
Prerequisites
Follow the safety guidelines listed in Safety instructions.
CAUTION: To prevent damage to the I/O connectors, do not touch connectors or the connector pins.
NOTE: Install the system partitions to install half-height system(s). For more information, see the PowerEdge VRTX
Enclosure Owner’s Manual at Dell.com/poweredgemanuals.
Steps
1. If you are installing a new system, remove the I/O connector cover from the I/O connector(s) and save for future use.
Figure 8. Removing the I/O connector cover
2. Orient the system so that the system handle is on the left side of the system.
CAUTION:
While installing the system into the enclosure, ensure that they are properly aligned with the
slots, to prevent damage to the system connectors.
3. Align the system with the system slot and guide rails on the enclosure.
4. Holding the system handle, slide the system into the enclosure until the system locks into place.
16
Installing and removing system components
To Next Page
Loading...
