Figure 10. Inside the system
1. drive cage 2. drive backplane
3. IDSDM card 4. air shroud
5. mezzanine card (fabric C) 6. I/O connector cover
7. Network Daughter Card (NDC) 8. mezzanine card (fabric B)
9. heat sink (CPU1) 10. heat sink (CPU2)
11. memory module (16) 12. system handle
System cover
Removing the system cover
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Turn off the system.
3. Remove the system from the enclosure.
4. Install the I/O connector cover.
Steps
1. Press the release button, and slide the cover toward the back of the system.
2. Lift the cover away from the system.
18
Installing and removing system components
To Next Page
Loading...
