Figure 40. Installing the Network Daughter Card
Next steps
1. Install the Mezzanine card.
2. Follow the procedure listed in After working inside your system.
PCIe mezzanine card
PCIe mezzanine card installation guidelines
Your system supports two PCIe mezzanine cards:
ā PCIe mezzanine card slot C supports Fabric C. This card must match the fabric type of I/O modules installed in I/O module
bays C1 and C2.
ā PCIe mezzanine card slot B supports Fabric B. This card must match the fabric type of I/O modules installed in I/O module
bays B1 and B2.
Removing the PCIe mezzanine card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Open the retention latch by pressing the ridged area on the retention latch, and lifting the latch up.
CAUTION: To prevent damage to the PCIe mezzanine card, you must hold the card only by its edges.
48 Installing and removing system components
To Next Page
Loading...
