Dell EMC PowerEdge R240 - Installing a 3.5-Inch Adapter into a 3.5-Inch Drive Carrier

Figure 27. Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
Next steps
Replace a 3.5-inch adapter into a 3.5-inch drive carrier.
Installing a 3.5-inch adapter into a 3.5-inch drive carrier
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Steps
1. Insert the 3.5 inch drive adapter into the drive carrier with the connector end of the drive toward the back of the drive carrier.
2. Align the screw holes on the drive with the holes on the drive carrier.
3. Install the screws to secure the drive to the drive carrier.
Figure 28. Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier
50
PowerEdge R240 installing and removing system components