Dell EMC PowerEdge R440 - Ports and Connectors Specifications

• Up to 4 x 3.5 inch drives with hard drive adapter, internal, hot swappable SAS, SATA, or Nearline SAS drives
• Up to 8 x 2.5 inch drives or 10 x 2.5 inch drives with hard drive adapter, internal, hot swappable SAS, SATA, or Nearline SAS drives
• Up to 4 x 3.5 inch drives or 8 x 2.5 inch drives or 10 x 2.5 inch drives with hard drive adapter, internal, hot swappable SATA SSDs
Ports and connectors specications
USB ports
The following table provides more information about the USB specications:
Table 19. USB specications
Front panel Back panel Internal USB
• One USB 2.0-compliant port
• One iDRAC Direct (Micro-AB USB)
port
• Two USB 3.0-compliant port • One internal USB 3.0 port
NIC ports
The PowerEdge R440 system supports two Network Interface Controller (NIC) ports on the back panel, which have two 1 Gbps
conguration.
NOTE
: You can install up to ve PCIe add-on NIC cards.
Serial connector
The serial connector connects a serial device to the system. The PowerEdge R440 system supports one serial connector on the back
panel, which is a 9-pin connector, Data Terminal Equipment (DTE), 16550-compliant.
VGA ports
The Video Graphic Array (VGA) port enables you to connect the system to a VGA display. The PowerEdge R440 system supports two 15-
pin VGA ports on the front and back panels.
Internal Dual SD Module
The PowerEdge R440 system supports two optional ash memory card slots with an internal dual MicroSD module.
NOTE
: One card slot is dedicated for redundancy.
Video specications
The PowerEdge R440 system supports Matrox G200eR2 graphics card with 16 MB capacity.
Technical
specications 27