Figure 79. Installing the BOSS cover
2. Connect the BOSS power cable and BOSS signal cable to the BOSS S2 module.
Figure 80. Connecting the BOSS power cable and BOSS Signal cable to the BOSS S2 module
3. Slide the BOSS S2 module into the BOSS module bay until it is firmly seated.
4. Using the Phillips #1 screwdriver, secure the BOSS S2 module on the BOSS module bay with the two M3 x 0.5 x 4.5 mm
screws.
5. Connect the BOSS power cable and the BOSS signal cable to the system board.
84
Installing and removing system components
To Next Page
Loading...
