Dell EMC PowerEdge R640 WNW58 - Air Shroud; Removing the Air Shroud; Installing the Air Shroud

Air shroud
Removing the air shroud
Prerequisites
CAUTION: Never operate your system with the air shroud removed. The system may get overheated quickly,
resulting in shutdown of the system and loss of data.
1. Follow the safety guidelines listed in Safety instructions on page 34.
2. Follow the procedure listed in Before working inside your system on page 35.
Steps
Hold the air shroud at both ends and lift it away from the system.
Figure 34. Removing the air shroud
Next steps
1. If applicable, install the air shroud.
2. Follow the procedure listed in After working inside your system on page 35.
Installing the air shroud
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 34.
2. Follow the procedure listed in Before working inside your system on page 35.
3. If applicable, route the cables inside the system along the system wall and secure the cables by using the cable latch.
Steps
1. Align the tabs on the air shroud with the slots on the system.
2. Lower the air shroud into the system until it is firmly seated.
Installing and removing system components
49