Dell EMC PowerEdge R640 WNW58 - Removing Expansion Card from the Expansion Card Riser

Figure 56. Installing the expansion riser 2A
Figure 57. Installing the expansion riser 2B
Next steps
1. Follow the procedure listed in After working inside your system on page 35.
2. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 34.
2. Follow the procedure listed in Before working inside your system on page 35.
3. If applicable, remove the air shroud.
4. If applicable, disconnect the cables from the expansion card.
5. When removing a card from riser 2 or 3, ensure that the PCIe card holder latch is closed.
80
Installing and removing system components