Dell EMC PowerEdge R640 - M.2 SSD Module; Removing the M.2 SSD Module

Figure 66. Installing expansion cards into the expansion riser 1A
Figure 67. Installing an expansion card into the expansion riser 2A
Next steps
1. After installing a card into the riser 1, close the PCIe card holder latch. If applicable, close the PCIe guide after installing the expansion
card.
2. Follow the procedure listed in After working inside your system on page 72.
3. Install any device drivers required for the card as described in the documentation for the card.
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 71.
122
Installing and removing system components