Next steps
1. Replace the RIO card and LOM card.
Installing the RIO card and LOM card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the system board.
NOTE: Upgrading the system board with the liquid cooling solution requires the liquid cooling RIO card.
Steps
1. Align the connectors and slots on RIO card and LOM card with the connector and standoffs on the system board.
2. Press the RIO card and LOM card until firmly seated on the system board connector.
3. Using a Phillips #2 screwdriver, secure the RIO card and LOM card to the system board with the two screws.
NOTE: The procedure to remove RIO on liquid cooling configuration is same.
Figure 132. Installing the RIO card
Next steps
1. Install the system board.
2. Follow the procedure listed in After working inside your system.
146
Installing and removing system components
To Next Page
Loading...
