Dell EMC PowerEdge R650 - Removing the expansion card risers

Table 44. Riser configuration 6: R3A + R1D Paddle card (continued)
Card type Slot priority
Qlogic (HBA: FC 32) 3
Qlogic (HBA: FC 16) 3
Qlogic (NIC: 10 Gb) 3
Qlogic - Marvell (NIC: 10 Gb) 3
Broadcom (NIC: 10 Gb) 3
Intel (NIC: 10 Gb) 3
Broadcom (NIC: 1 Gb) 3
Intel (NIC: 1 Gb) 3
Mellanox (NIC: HDR100 VPI) 3
Mellanox (NIC:HDR VPI) 3
Marvell (OCP: 25 Gb) Integrated slot
Mellanox (OCP: 25 Gb) Integrated slot
SolarFlare (OCP: 25 Gb) Integrated slot
Broadcom (OCP: 25 Gb) Integrated slot
Intel (OCP: 25 Gb) Integrated slot
Broadcom (OCP: 10 Gb) Integrated slot
Intel (OCP: 10 Gb) Integrated slot
Qlogic (OCP: 10 Gb) Integrated slot
Broadcom (OCP: 1 Gb) Integrated slot
Intel (OCP: 1 Gb) Integrated slot
GPU / Others
Inventec (Serial) 3
NOTE: The system supports either BOSS-S1 or BOSS-S2. It cannot support both the cards together.
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Disconnect any cables that are connected to the expansion card.
Steps
1. For Riser 1, press the blue tab and holding the edges lift the expansion card riser from the riser connector on the system
board.
94
Installing and removing system components