Figure 115. Cabling diagram—1.8 Inch (x18) SAS/SATA backplane
1. hard drive backplane expander 2. system board
3. backplane signal connector 0 4. backplane signal connector 1
5. integrated storage controller card 6. hard drive backplane
Next steps
1. Install the hard drive backplane.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system on page 68
Removing a hot swappable hard drive or solid state drive on page 163
Removing the cooling shroud on page 75
Removing the cooling fan assembly on page 88
Installing the hard drive backplane on page 181
180 Installing and removing system components
To Next Page
Loading...
