Dell EMC PowerEdge R750 - Removing a Memory Module

Table 52. Intel Persistent Memory 200 series (BPS) Configuration 6 - 12 x RDIMMs/ LRDIMMs, 2 x Intel
Persistent Memory 200 series (BPS) per processor
Total No of
RDIMMs /
LRDIMMs
Total No of
Intel
Persistent
Memory 200
series (BPS)
DIMMs
1 R/LRDIMM
capacity (GB)
1 Intel
Persistent
Memory 200
series (BPS)
capacity (GB)
Total Standard
Memory Capacity
(GB)
Total PM
Capacity
(GB)
Supported Modes
12 2 16 128 192 256 AD
12 2 32 128 384 256 AD
12 2 64 128 768 256 AD
12 2 128 128 1536 256 AD
12 2 256 128 3072 256 AD
12 2 16 256 192 512 AD
12 2 32 256 384 512 AD
12 2 64 256 768 512 AD
12 2 128 256 1536 512 AD
12 2 256 256 3072 512 AD
12 2 16 512 192 1024 AD
12 2 32 512 384 1024 AD
12 2 64 512 768 1024 AD
12 2 128 512 1536 1024 AD
12 2 256 512 3072 1024 AD
Removing a memory module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud or remove the GPU air shroud.
WARNING:
The memory modules are hot to touch for some time after the system has been powered off. Allow
the memory modules to cool before handling them.
Steps
1. Locate the appropriate memory module socket.
2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module
socket to fully open.
CAUTION:
Handle each memory module only by the card edges, ensuring not to touch the middle of the
memory module or metallic contacts.
3. Lift the memory module away from the system.
104
Installing and removing system components