Figure 86. Removing the control panel assembly
4 To remove the information tag, perform the following steps:
a Locate and press the tabs on the information tag.
b Push the information tag out of the slot to remove it from the control panel.
NOTE
: Retain the information tag to replace it in the new control panel.
Installing the control panel assembly
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
138
Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components
To Next Page
Loading...
