Dell EMC PowerEdge T440 - Page 27

The embedded system diagnostics provides a set of options for particular device groups or devices allowing you to:
• Run tests automatically or in an interactive mode.
• Repeat tests
• Display or save test results.
• Introduce more test options for extra information about the failed devices, run a thorough test.
• View status messages that inform you if tests are completed successfully.
• View error messages that inform you of problems encountered during testing.
Running the Embedded system diagnostics from Boot Manager
To run the embedded system diagnostics from Boot Manager:
1 As the system boots, press <F11>.
2 Using the arrow keys select System Utilities → Launch Diagnostics.
3 Wait while the Quick Tests automatically run.
Dell EMC PowerEdge T440 Installation and Service Manual
Diagnostic indicators
27