Figure 28. Removing a drive blank
Next steps
1 Follow the procedure listed in After working inside your system.
2 Install a drive or a drive blank.
3 If applicable, replace the front bezel.
Related link
Removing the front bezel
Installing a drive blank
Installing a drive blank
The procedure for installing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisite
Follow the safety guidelines listed in Safety instructions.
CAUTION
: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components
79
To Next Page
Loading...
