a Loosen the rst screw three turns.
b Loosen the second screw completely.
c Return to the rst screw and loosen it completely.
NOTE: It is normal for the heat sink to slip o the blue retention clips when the screws are partially
loosened, continue to loosen the screw(s).
2 Pushing both blue retention clips simultaneously, lift the out of the system.
3 Set the PHM aside with the processor side facing up.
Figure 58. Removing the processor and heat sink module
Next step
Install the PHM.
Related link
Removing the air shroud
Installing a processor and heat sink module
116
Installing and removing system components
To Next Page
Loading...
