System component description
19
Overview
SP
Viewing from the rear of the DPE, each SP (B and A), respectively, consists of connectors,
status LEDs, latch handles, and so on.
◆ AC power supply module:
• Power in (recessed) connector (plug)
• Power supply status LEDs (power on and fault)
• Power supply latch handle
◆ SP B and A:
•USB
• Two 1-GbE iSCSI (host IP connect) ports
• Two 6-Gb/s SAS x4 ports (labeled 6Gb SAS 0 x4 and 1 x4)
Note: 6Gb SAS port 1 x4 is not used at this time.
• Optional four-port 1-Gb/s copper Ethernet I/O personality module
• Two (RJ-45) LAN connectors (labeled with a network management symbol and a
wrench symbol)
Note: The RJ-45 LAN connector with a wrench symbol is not used at this time.
• Two (micro DB-9) RS-232/EIA connectors (labeled with a battery symbol and a
wrench symbol)
Note: The DB-9 connector with a battery symbol is not used at this time.
•SP status LEDs
• RS-232/EIA
• SP latch handles (top of SP left and right)
Figure 8 on page 20 shows the location of these SP components.
To Next Page
Loading...
