System component description
23
Overview
Figure 10 SP connectors, status LEDs, latch handles, and so on
1 RS-232/EIA (micro DB-9) connector
(labeled with a wrench symbol)
7 CRU fault LED (amber
1
)
1. CRU fault LED lights amber when an internal CRU is faulted.
2 Management LAN (RJ-45) port (labeled
with a network management symbol)
8 SP unsafe to remove LED (white)
3 Service LAN (RJ-45) port (labeled with a
wrench symbol); not used at this time
9 SP power LED (green)
4 Shows an example of a four-port 1-Gb/s
(1000Base-T) copper Ethernet I/O
personality module (labeled e0, e1, e2,
and e3); a two-port 10-Gb/s copper
Ethernet I/O personality module is also
available but only supported in a dual SP
configuration
10 SP status/fault LED (amber/blue
2
)
2. The SP fault status LED (amber or blue), flashes at different rates, depending on the current status of the SP.
In a normal, operational state, it will be off.
5 SP latch handle (middle, left and right) 11 RS-232/EIA (micro DB-9) connector
(labeled with a battery symbol); not used
at this time
6 Two 1-GbE iSCSI (host IP connect) ports
(labeled 2 and 3)
12 Two 6-Gb/s SAS ports (labeled 6Gb SAS
0 x4 and 1 x4); port 1 x4 is not used at this
time
1 GBE
01
X4
6Gb SAS
6Gb SAS
23
1
0
e3e0 e1 e2
1 GbE
5
4
1
3
2
6
7
8
10
9
11
12
VNX-000099
To Next Page
Loading...
