Dell EMC VxFlex Series - Page 74

l
Disconnect the iDRAC remote image:
racadm -r <dracIP> -u root -p <password> remoteimage –d
Where:
n
<dracIP> is the iDRAC IP address
n
<password> is the password for the server
Note
The default password is Scaleio123.
2. Issues when booting to iDRAC virtual media may cause CPU machine check errors
at POST. When this occurs, clear the iDRAC job queue and reset the iDRAC, as
described in Troubleshoot general iDRAC failures on page 73.
Rebranding operation fails
When updating the Personality Module on 14G servers using the DTK, the operation
may fail and the following error message may appear:
UEFI0052 Unable to complete the rebranding operation.
To resolve the problem, upload the PM file manually:
1. Contact Customer Support for the VxFlex OS PM file.
2. Follow the instructions in the VxFlex OS Upgrade Guide for "Single server firmware
and BIOS upgrade to a specific version" to upload the file.
Check the logs for error messages
You can view VxFlex Ready Node Hardware Update Bootable ISO logs after the
update script completes.
Procedure
1. Press Alt-F2 to access a user console, and then press Enter.
2. Open the log to check the contents for errors:
less /bundleapplicationlogs/apply_components.log
3. You can also view the script for the Hardware ISO, which is useful in helping to
identify and troubleshoot log entries:
less /opt/dell/toolkit/systems/drm_files/apply_bundles.sh
Results
The script attempts to configure several boot order commands, regardless of the
hardware configuration of the VxFlex Ready Node server. This allows the script to
support multiple hardware platform configurations.
Therefore, it is normal to see these error messages within the logs:
Reference material
74 Hardware Configuration and Operating System Installation Guide - ESXi Servers