Dell EqualLogic PS-M4110 Installation Guide
Using the CMC GUI to Configure the Array
Figure 14: Storage Array Information Screen
6.
The Configure Array page is displayed. See Figure 15. In the Array Configuration section, enter the required
information for each attribute value to configure the array. Refer to Figure 15 for an example of the attribute
values that are entered. The attribute values that you must enter are described in Collecting Configuration
Information on page 25.
7.
On the same Configure Array page, in the Storage Network Settings section, specify the Selected Fabric
value from the drop-down box if you want to change the fabric from the default. The default value is Fabric-
B. See Figure 15.
To Next Page
Loading...
