Dell EqualLogic PS-M4110 Installation Guide
Chapter 4 Configuring the Array
Figure 15: CMC Configure Array Screen
8.
Click the Apply button to save the information. See Figure 15.
9.
If you have entered valid information in the configuration screen, an Operation Successful message is
displayed, as shown in Figure 16.
If the information that you entered is not valid, an Operation Failed message is displayed. In this case, you
must go back to the configuration screen to re-enter configuration attributes.
If there is a problem performing the configuration, you will need to use a serial or racadm connection to
access the EqualLogic CLI and troubleshoot the problem.
To Next Page
Loading...
