Dell EqualLogic PS-M4110 Installation Guide
Using the CMC GUI to Configure the Array
Figure 16: Configuration Successful Acknowledgement
Note: Once the array configuration is completed, only the Storage Network Settings (Selected
Fabric value) will continue to be displayed on the Configure Array page. Other array
properties that have been configured are no longer shown. See Figure 5. (These set-
tings can be viewed on the Storage Properties page. See Figure 6.)
Figure 17: Confirm the Fabric Setting
10.
Confirm the Selected Fabric setting by clicking the Return to Storage Array Status button. See Figure
17.
Note: If the Selected Fabric is not correct, you can change it by selecting a different fabric in the Attribute
Value dropdown box. Then click the Apply button. Once the fabric is correctly set, click the Return to
Storage Array Status button. See Figure 17.
11.
When you have finished the configuration, the Storage Array Status screen is displayed. See Figure 18. It
shows you the settings that you have specified during configuration. Examine the settings to assure that they
are what you intended. Note that you can reconfigure the array by clicking the Configure Array button.
To Next Page
Loading...
