Dell Force10 C150 - Page 1125

Virtual Routing and Forwarding (VRF) | 1125
The following shows the output of the show commands on Router 2.
ROUTER 2
FTOS#show ip vrf
VRF-Name VRF-ID Interfaces
default-vrf 0 Gi 1/0-89,
Te 3/0-3,
Gi 4/0-89,
Gi 5/0-89,
Gi 6/0-89,
Gi 9/0-17,21-47,
Gi 11/0-47,
Gi 12/0-47,
Gi 13/0-47,
Ma 0/0,
Ma 1/0,
Nu 0,
Vl 1
blue 1 Gi 9/18,
Vl 128
orange 2 Gi 9/19,
Vl 192
green 3 Gi 9/20,
Vl 256
FTOS#show ip ospf 1 neighbor
Neighbor ID Pri State Dead Time Address Interface Area
1.0.0.1 1 FULL/BDR 00:00:36 1.0.0.1 Vl 128 0
!
FTOS#sh ip ospf 2 neighbor
Neighbor ID Pri State Dead Time Address Interface Area
2.0.0.1 1 FULL/BDR 00:00:33 2.0.0.1 Vl 192 0
!
FTOS#show ip route vrf blue
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
C 1.0.0.0/24 Direct, Vl 128 0/0 00:27:21
O 10.0.0.0/24 via 1.0.0.1, Vl 128 110/2 00:14:24
C 11.0.0.0/24 Direct, Gi 9/18 0/0 00:19:46
------continued next page -------