Dell Force10 C150 - Page 1134

1134 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
Figure 58-6 shows the same VRRP group configured on multiple interfaces on different subnets.
Figure 58-6. Command Example Display: show vrrp
When the VRRP process completes its initialization, the State field contains either Master or Backup.
Note: show vrrp displays all of the active IPv4 groups, and show ipv6 vrrp displays all of the active IPv6
groups.
FTOS#do show vrrp
------------------
GigabitEthernet 1/1, VRID: 111, Net: 10.10.10.1
State: Master, Priority: 255, Master: 10.10.10.1 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 1768, Gratuitous ARP sent: 5
Virtual MAC address:
00:00:5e:00:01:6f
Virtual IP address:
10.10.10.1 10.10.10.2 10.10.10.3 10.10.10.10
Authentication: (none)
------------------
GigabitEthernet 1/2, VRID: 111, Net: 10.10.2.1
State: Master, Priority: 100, Master: 10.10.2.1 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 27, Gratuitous ARP sent: 2
Virtual MAC address:
00:00:5e:00:01:6f
Virtual IP address:
10.10.2.2 10.10.2.3
Authentication: (none)
FTOS#
Different Virtual
IP addresses
Same VRRP Group (VRID)