Dell Force10 C150 - Page 830

830 | Port Monitoring
www.dell.com | support.dell.com
Figure 38-12 shows a sample configuration of remote port mirroring on a destination switch. Note that in
the
show monitor session output of a destination session, the source is the reserved VLAN (for example,
remote-vlan 22) and the destination is the destination port (for example, Gi 4/73) to which an analyzer is
attached.
Figure 38-12. Configuring Remote Port Mirroring: Destination Switch
FTOS(conf)#interface vlan 22
FTOS(conf-if-vl-22)#mode remote-port-mirroring
FTOS(conf-if-vl-22)#tagged gi 4/48
FTOS(conf-if-vl-22)#no shutdown
FTOS(conf-if-vl-22)#exit
FTOS(conf)#monitor session 100
FTOS(conf-mon-sess-100)#source remote-vlan 22 destination gi 4/73
FTOS(conf-mon-sess-100)#tagged destination gi 4/73
FTOS(conf-mon-sess-100)#show config
monitor session 100
source remote-vlan 22 destination GigabitEthernet 4/73
FTOS(conf-mon-sess-100)#end
FTOS#show monitor session 100
SessionID Source Destination Direction Mode Type
--------- ------ ----------- --------- ---- ----
100 remote-vlan 22 Gi 4/73 N/A Remote-Port-Mirroring N/A