Dell Force10 MXL Blade - Page 159

Data Center Bridging | 159
dcb-policy input stack-unit stack-ports all
Apply the specified DCB input policy on all ports of the switch stack or a single stacked switch.
Syntax
dcb-policy input stack-unit {all | stack-unit-id} stack-ports all dcb-input-policy-name
To remove all DCB input policies applied to the stacked ports and rest the PFC to its default settings,
use the no dcb-policy input stack-unit all command.
To remove only the DCB input policies applied to the specified switch, use the no dcb-policy input
stack-unit
command.
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Usage
Information
The dcb-policy input stack-unit all command overwrites any previous dcb-policy input stack-unit
stack-unit-id
configurations. Similarly, a dcb-policy input stack-unit stack-unit-id command
overwrites any previous dcb-policy input stack-unit all configuration.
Related
Commands
dcb-policy output
Apply the output policy with the ETS configuration to an egress interface.
Syntax
dcb-policy output policy-name
To delete the output policy, use the no dcb-policy output command.
Parameters
Defaults
none
Command Modes
INTERFACE
Command
History
Usage
Information
When you apply an ETS output policy to on interface, ETS-configured scheduling and bandwidth
allocation take precedence over any configured settings in QoS output policies.
stack-unit-id
Enter the stack unit identification.
dcb-input-policy-
name
Enter the policy name for the DCB input policy.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
dcb-policy output stack-unit
stack-ports all
Apply the specified DCB output policy.
policy name
Enter the output policy name.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module